Home  /  Services  /  Bathrooms

01 · Bathroom renovations · Melbourne

Bathroom renovations that start below the surface.

We’re an independent home renovation specialist with around 15 years of hands-on experience. You deal directly with the person who inspects your bathroom, gives you honest advice and does the strip-out, preparation, tiling and finishing. That person takes personal responsibility for the work.

A hand uses a flat finishing tool to apply or smooth white plaster or render on an interior wall around a tiled or panelled section.

Illustrative photo: smoothing render on a wall before tiling.

At the inspection

What we check before quoting a bathroom

  • Worn surfaces: cracked, loose or drummy wall and floor tiles and tired grout.
  • Substrates: walls and floors that are uneven or out of level and would show through new tiles.
  • Signs of moisture: staining, soft spots or damage that points to a problem behind the surface.
  • Concealed damage: areas that may only be fully understood once the old tiles come off.
  • Licensed trades: which parts of the job need a licensed plumber or electrician.

The site visit and quote are free. See how the inspection works.

From strip-out to finish

What a bathroom renovation involves on our side

A good renovation depends on what happens before the final finishes go in. Most of the visible result comes down to the stages you never see.

01

Careful strip-out

We remove the old tiles, adhesive and fittings that are being replaced, and protect the rest of your home while we work. This is often the point where the real condition of walls and floors becomes clear.

02

Surface preparation

We check substrates, then repair and level them so the new tiles have a sound, flat base. More on surface preparation.

03

Wall and floor tiling

We set out the layout first so cuts and joints sit where they should, then lay and grout the tiles. Read about our wall and floor tiling.

04

Finishing and walk-through

We finish the edges and details, clean up, then walk through the finished room with you so you can see the work and ask questions.

What we coordinate

Plumbing and electrical work goes to licensed tradespeople

We don’t personally carry out licensed plumbing or electrical work. If your bathroom needs it, we coordinate with appropriately licensed tradespeople and plan the tiling and finishing around their work.

Architectural design, engineering and other specialist professional services aren’t part of what we offer, and we don’t run a 24-hour emergency service.

How we work with licensed tradespeople →

Before you commit

Scope, cost and timing depend on what we find

Every bathroom is different, so the right scope of work, materials and methods depend on the property’s condition and what the assessment shows. We explain what work is needed and why we recommend a particular approach, so you can decide with the full picture.

Concealed damage, such as deterioration behind old tiles, or changes to the agreed scope can affect the work. If either comes up, we stop and talk it through with you before going any further. Read about concealed damage and changes to scope.

Completed walk-in shower with marble-effect wall tiles, small mosaic floor tiles, glass enclosure, grab bars and recessed shelving.

Illustrative photograph

Start with a text and a few photos

Send a short description of your bathroom, ideally with a few clear photos or a short video, to 0413 142 055. Ivan reviews every enquiry personally and can arrange a free site visit to inspect the room and discuss what you need. We work across Melbourne and surrounding suburbs.